The shipment of LQ ammo by international air is forbidden. It is permissible to leave the LQ mark on the package and it will be ignored, and then of use for the road leg of the journey after air transport.

Use these Transport Data Sheets:

UN 0012: Ammo, International Air
UN 0014: Blank Ammo, International Air

An explanation follows.

LIMITED QUANTITIES

Unlike other modes of transport, small arms ammunition is forbidden to ship as a limited quantity by international air. Industry is not pursuing the ability to ship ammo as LQ by international air because:

• Unlike other modes where LQ has significant cost savings, the only exception by air is from package testing; there is no exception from shipping papers or labeling.
• Unlike other modes where the 5 kg limitation applies to each inner package, the 5kg limit in international air applies to the entire shipping case. A majority of ammunition packages would not qualify.
• Many airlines have filed variations prohibiting LQ shipments.

As a consequence, industry got the LQ surface mark approved for LQ air transport domestically in the USA, and obtained an example in IATA that the LQ surface mark may remain on the package and be ignored in international air. This eliminates the labor to remove it, and allows the package to be LQ during the international journey on the surface leg subsequent to air transport.

Therefore the LQ-Y mark should never be used.

Citations: IATA 2.8.3.5 (operator restrictions); Dangerous Goods List Columns G & H (LQ is forbidden); 7.1.5.5 and Figure 7.2.A (the ground LQ mark is allowed and ignored)

COMMODITY:  Empty Primed Cartridge Cases (shotshell, rimfire and centerfire)

SPECIAL: Limited Quantity of Division 1.4S – 50 caliber or less

MODE OF TRANSPORTATION: Domestic Air. USA regulations may be used when shipping via UPS. FedEx only uses international air regulations. For other carriers, ask them if you can use 49 CFR, the USA Hazardous Materials Regulations of the DOT.

OVERVIEW

PROPER SHIPPING NAME:	Cases, cartridge, empty with primer	LABEL:	No
IDENTIFICATION NUMBER:	UN 0055	PLACARD:	No
HAZARD CLASS/DIVISION:	1.4S	EMERG. INFO:	No
PACKING GROUP:	None	TRAINING:	Required
DOCUMENT:	No	PACKAGING:	Special
MARKING:	LQ Mark

HAZMAT TABLE

(1)Sym-bols

(2)Hazardous materials descriptions and proper shipping names

(3)Hazard class or Division

(4)Identifi-cation Numbers

(5)PG

(6)Label Codes

(7)Special provisions(§172.102)

(8)Packaging (§173.***)

(9)Quantity Limitations(see §§173.27 and 175.75)

(10)Vesselstowage

Excep-tions

Non- bulk

Bulk

Passenger aircraft/ rail

Cargo aircraft only

Loca- tion

Other

(1)

(2)

(3)

(4)

(5)

(6)

(7)

(8A)

(8)

(8C)

(9A)

(9B)

(10A)

(10B)

Cases, cartridge, empty with primer

1.4S

UN0055

none

63

62

None

25kg

100kg

01

25

PACKAGING INFORMATION

Empty primed cartridge cases that have been classed as Division 1.4S explosive may be transported as limited quantities when packaged as follows:

• Ammunition must be packed in inside boxes, or in partitions that fit snugly in the    outside packaging, or in metal clips; no single packages allowed i.e. inner packages are required.
• Except for 22 rimfire, primers must be protected against packaging or another cartridge base.
• Inside boxes, partitions or metal clips must be packed in securely-closed strong outside packagings; no specification testing is required.
• The maximum gross weight is limited to 30 kg (66 pounds) per package.

Citation: 49 CFR 173.63 (b)(2)

SHIPPING PAPER REQUIREMENTS

Unlike domestic road, domestic air shipments are not excepted from documentation. The documentation is like for 1.4S domestic road, except that “LTD QTY” is added to the end of the shipping description. Like for domestic road, the net weight is an acceptable alternative for the net explosives weight.

HM	DESCRIPTION	WEIGHT/LBS.
X	UN 0055, Cases, cartridge, empty with primer, 1.4S, LTD QTY	(Insert net weight or net explosives weight)

Citation: 49 CFR 173.63(b)(1)(i)

CARTON MARKING

Limited quantity packages containing empty primed cartridge cases must display the  limited quantity marking on one side. Unlike for domestic road, the UN number and proper shipping name are required for domestic air. The 1.4S hazard label is not required, but in this example we use a sticker that combines the 1.4S label, “Cases, cartridge, empty with primer” and “UN 0055”.

In addition, each carton may have to be marked with the consignor’s or the consignee’s name and address, see 49 CFR §172.301(d) for exceptions*.

* Per 49 CFR §172.301(d), the package must be marked with the consignor or consignee’s name and address unless the package is:

(1) Transported by highway only and will not be transferred from one carrier to the other;

(2) Part of a carload lot, truckload lot or freight container load, and the entire contents of the rail car, truck or freight container are shipped from one consignor to one consignee.

Citation: 49 CFR §173.63(b)(1)(i), 49 CFR §172.301(d) & §172.315 (a)

OVERPACKS

The “OVERPACK” marking is only required if the limited quantity marking is not visible, in which case the “Limited Quantity” and “overpack” stickers are required on only one side of the pallet or overpack box.

Citation: 49 CFR §173.25(a)(6)

COMMODITY: Blank small arms ammunition (shotshell, rimfire and centerfire) as 1.4S; 25 kg net maximum per package; 50 caliber / 8 gauge or less, or above 50 Cal/8 gauge with an EX approval.

MODE OF TRANSPORTATION: International Air

CLASSIFICATION & REQUIREMENTS

PROPER SHIPPING NAME:	Cartridges, small arms, blank	LABEL:	1.4S
IDENTIFICATION NUMBER:	UN0014	PLACARD:	N/A
HAZARD CLASS/DIVISION:	1.4S	EMERGENCY:	Yes
PACKING GROUP:	None	TRAINING:	Every 2 Years
DOCUMENT:	Special	PACKAGING:	PI 130
MARKING:	Yes

DANGEROUS GOODS LIST

LIMITED QUANTITIES

Unlike other modes of transport, small arms ammunition is forbidden to ship as a limited quantity by international air. Industry is not pursuing the ability to ship ammo as LQ by international air because:

• Unlike other modes where LQ has significant cost savings, the only exception by air is from package testing; there is no exception from shipping papers or labeling.
• Unlike other modes where the 5 kg limitation applies to each inner package, the 5kg limit in international air applies to the entire shipping case. A majority of ammunition packages would not qualify.
• Many airlines have filed variations prohibiting LQ shipments.

As a consequence, industry got the LQ surface mark approved for LQ air transport domestically in the USA, and obtained an example in IATA that the LQ surface mark may remain on the package and be ignored in international air. This eliminates the labor to remove it, and allows the package to be LQ during the international journey on the surface leg subsequent to air transport.

Therefore the LQ-Y mark should never be used.

Citations: IATA 2.8.3.5 (operator restrictions); Dangerous Goods List Columns G & H (LQ is forbidden); 7.1.5.5 and Figure 7.2.A (the ground LQ mark is allowed and ignored)

PACKAGING INFORMATION

Cartridges, small arms, blank, 50 cal or less may be self-classified by the manufacturer (without an EX approval) as UN 0012, Cartridges, small arms, Division 1.4S explosive and packaged without written government approval, as follows :

• The package must be tested, and bear the specification package mark.
  
• The maximum gross weight is typically 400 kg (882 pounds) per package (bearing in mind the maximum net weight is 25 kg for passenger aircraft or 100 kg for cargo-aircraft-only).
• Ammunition must be packed per Packing Instruction 130; inner and intermediate packaging is allowed but not required. These outer packagings are allowed:
  
• The packaging codes are specifications with minimum standards of construction and maximum gross weights.

Citation: IATA 6.0.4.1 marking, 6.2 specifications, 6.3 testing

SHIPPING PAPER REQUIREMENTS

International air transport is subject to the requirements of IATA, the International Air Transport Association. A special document is required called a Dangerous Goods Declaration (DGD) in addition to any standard bill of lading. Fill out the DGD as follows in four sequences:

Sequence 1 – Dangerous Goods Identification

The sequence is: “UN 0014, Cartridges, small arms, blank, 1.4S”. There is no packing group.

For multiple products, each change to Sequence 1 must be on a new line.

Sequence 2 – Quantity and Type of Packing

The sequence is “QUANTITY PACKAGING:MATERIAL-TYPE X NET-QUANTITY, NEQ”, e.g. “5 fibreboard boxes X 11 kg, 1 kg NEQ”. Quantity is the number of shipping cases (packages). The degree of rounding is not specified, but may be to the nearest kilogram, and should be consistent between the DGD, package and overpack markings. Packaging type is material and type, e.g. “fibreboard boxes” or “steel drums”. Metric units must be used, which for solids is “kg”, not capitalized. For ammunition, NEQ is the powder and primer mix; however the amount of primer mix is often only 1/100^th of the powder and may be lost in the rounding.

For multiple products, each change to Sequence 2 must be on a different line, e.g. different net weight, but Sequence 1 does not have to be repeated if together. See IATA DGR Figure 8.1.K.

When overpacks are used:

• Packaging in overpacks must be listed first.
• The wording “Overpack Used” must be inserted on the declaration form immediately after all the entries in the overpack.
• When a consignment consists of multiple overpacks each overpack must have an identification marking any alpha-numeric format) and be marked with the total quantity of dangerous goods within the overpack including the unit of measurement.
• The total quantity(ies) shown on the Shipper’s Declaration must match the total quantity(ies) shown on the overpack.
• Multiple overpacks with identical contents must be identified as follows: “Overpack Used X (number of identical overpacks)”, (see IATA Figure 8.1.L and Figure 8.1.N, examples 8 and 10). Multiple overpacks with different contents must be identified by listing them separately

Sequence 3 –Packing Instruction

Write the number of the applicable packing instruction, “130”.

Sequence 4 – Authorizations

Normally the EX number should be provided and attached. This UN number does not require EX approvals for 50 caliber / 8 gauge and below. Instead, make a statement and cite USG-05, a US government variation stating that they require EX numbers, but that small arms ammunition is excepted per 49 173.56(h), e.g. “These articles are of the kind described in 49 CFR 173.56(h), and are authorized by USG-05 without documentation”.

Citation: IATA 8.1.6.9

CARTON MARKING & LABELING

Packages containing small arms ammunition must display the following markings and at least 6mm (1/4”) high, or an appropriate size for packages which are ≤5 kg net, as follows:

• Proper shipping name – “Cartridges, small arms, blank”
• UN# – “UN 0014”
• the full name and address of the shipper and the consignee, located on the same package surtace and near the proper shipping name, if the package dimensions are adequate;
• the net quantity, in kilogram units abbreviated “kg” in lower case letters, e.g. “15.2 kg”. This quantity must be marked adjacent to the UN number and proper shipping name. It may be rounded to the nearest kilogram, or to a desired level of decimals for better accuracy and alignment with the overpack weight. The net quantity should be identical to that shown on the Dangerous Goods Declaration document.
• the specification package marking, placed in a location and of such size relative to the package as to be readily visible. Must be pre-printed or affixed, and not handwritten. For packages with a gross weight exceeding 30 kg the marking, or a duplicate thereof, must appear on the top or on the side of the package. For example:
  

The 1.4S hazard label must be applied as follows:

• When the package dimensions are adequate, labels must be located on the same surface of the package near the proper shipping name marking.
• Labels should be affixed adjacent to the shipper’s or consignee’s address appearing on the package.
• Unless the package dimensions are inadequate, the label(s) must be affixed at an angle of 45 degrees (diamond shaped) to the surrounding markings.

The LQ mark is not valid on ammo in international air transport, but may remain on the package and be ignored in air transport, and be valid for further surface transport when the air journey is over.

Citation: IATA 6.0.4.1, 7.1.4, 7.1.5, 7.2.6.2

OVERPACK MARKINGS

Examples of overpacks include pallets and specification packages placed in another packaging. International air transport is subject to the requirements of IATA, the International Air Transport Association, which requires unique pallet markings.

Unless all markings and labels representative of all dangerous goods in the overpack are clearly visible, the overpack must be marked with:

• the word “OVERPACK” in letters at least 12 mm (1/2”) high;
• UN number
• proper shipping name
• full names and addresses of the consignor and consignee

The following requirements apply even if all markings are visible:

• If there is more than one UN number in an overpack, write each UN number and the total quantity of dangerous goods for each UN number.
• If there are two or more overpacks, name and mark each pallet with a unique identification mark (which may be in any alpha-numeric format) and the total quantity of dangerous goods, as indicated on the Dangerous Goods Declaration.

Normally we would use this OVERPACK sticker for domestic shipments:

However since there is so much information required, we print it on a piece of paper instead, with OVERPACK and the UN number in 1/2″ print, and affix it to the pallet:

Citation: IATA 7.1.7